- Amateurradio
- Antennes
- Diamond Basis
- Diamond Mobiel
- Diamond Porto
- Comet Basis
- Comet Mobiel
- Comet Porto
- Komunica Basis
- Komunica Mobiel
- Komunica Porto
- Jetfon Basis
- Jetfon Mobiel
- Jetfon Porto
- D-Original Basis
- D-Origina Mobiel
- D-Original Porto
- Sirio-Basis
- Sirio-Mobiel
- Sirio-Porto
- K-Po-Basis
- K-Po-Mobiel
- K-Po-Porto
- Moonraker-Basis
- Moonraker-Mobiel
- Moonraker Porto
- Diversen Basis
- Diversen Mobiel
- Diversen Porto
- Accessoires
- Draad Antennes
- Richtantennes
- HF Verticaal
- Anjo Richt Antennes UHF-VHF
- Anjo Basis Antennes
- Anjo Mobiele Antennes
- Anjo Logperiodieke Antennes
- Anjo Quad Antenns
- Anjo Yagi Antennes
- Anjo Draad Antennes
- Anjo HF Antennes
- Faseleiding
- Kabel
- Connectoren
- Antenne Tuners
- Swr / Pwr meters
- Voedingen
- Toebehoren HAM Radio
- Coax Switch & Relay
- Analyzers
- Rotoren
- Amplifier
- 27Mhz / CB-Radio / Antenne
- SDR / Scanners / Radio
- Broadcast
Nieuwe producten
Nieuwe producten
The mAT-K100 provides automatic antenna tuning across the entire HF spectrum plus 6 meters, at power levels up to 120 watts. It will tune dipoles, verticals, Yagis, or virtually any coax-fed antenna. It will match an amazing range of antennas and impedances, far greater than some other tuners you may have considered, including the built-in tuners on many radios.
The mAT-K100 is an automatic antenna tuner specially designed for modern ICOM and KENWOOD HF transceivers. It has two control cables to choose from: mAT-CI and mAT-CK. They are suitable for ICOM and KENWOOD transceivers respectively. With matching control cables, tuners can be used for corresponding transceivers. mAT-K100 standard accessories only contain KENWOOD control cable mAT-CK, if you need mAT-CI, please buy more.
When mAT-K100 is used in ICOM transceiver through mAT-CI control cable, it is fully compatible with the original AH-3 and AH-4 automatic tuners of ICOM. Transceivers that can use both ICOM tuners can also use mAT-K100, which includes IC-706, 703, 718, 7000, 7100, 7200, 7300, 7410, 746, 756, 7600 series transceivers.
When the tuner is used in KENWOOD transceiver through mAT-CK control cable, it is fully compatible with KENWOOD original tuners, such as AT-250, AT-300. KENWOOD transceivers that can use mAT-K100 are TRC-80, TK-80, TS-2000, 50, 450, 480SAT (excluding HX version), 570, 590, 850, 870, 990, etc. Other types of transceivers can use mAT-K100 as long as they support KENWOOD AT-300 tuners. KENWOOD TS-430, TS-440 are too old to use this tuner.
The mAT-K100 has 16,000 frequency memories. When tuning on or near a previously tuned frequency, the mAT-K100 uses "Memory Tune" to recall the previous tuning parameters in a fraction of a second. If no memorized settings are available, the tuner runs a full tuning cycle, storing the parameters for memory recall on subsequent tuning cycles on that frequency. In this manner, the mAT-K100 "learns" as it is used, adapting to the bands and frequencies as it goes.
No customer reviews for the moment.
Bijpassende producten
15 meer producten uit dezelfde categorie:
-
Handelsonderneming Veenstra
Middenweg 98 (Loods)
Zijtak WZ25
7844 KZ Veenoord
Nederland
+31(0)591564098 +31(0)6 25245777
info@handelsondernemingveenstra.nl
Klantenservice
This shop uses cookie to ensure you get the best experience on our sites.